Hopper Weathering II

Hopper Weathering Clinic II By Bill Mock December 2009

So here's how those BN Hoppers turned out after the surface rust dried. Not bad. I'll see if they need another wash. Maybe I'll just chalk them. But I now need to add some spots of rust; some random and some at the ladder, etc.

OK, it's after working hours, time to add some surface rust. So I start off by wetting the entire surface with "blue" windshield washing fluid. Then I mix a very diluted wash of Raw Umber acrylic paint and more blue windshield washing fluid. I wash this on to the surface and let it pool in the edges and build up. Then, walk away. Check back to make sure that the wet surface is drying evenly. If the wash dries unevenly and edges start to form, dab your brush in a little plain blue washing fluid. Dry the brush on a paper towel. Then with the now damp brush, lightly brush over the unwanted paint edge. If caught early, it should dissolve this "edge" and leave a nice even wash again. This method is very similar to watercolour painting techniques. Check back tomorrow for photos of the Hoppers when they are dry.

Hopper Weathering Clinic II how to was written by Bill Mock in December 2009. This article has been assembled in order by the following links. Simply cut and paste the following links into your web browser to follow up on any additional comments, suggestions, or to view the larger images.

http://www.zcentralstation.com/index.php?view=detail&;id=2460&option=com_joomgallery&Itemid=178

http://www.zcentralstation.com/index.php?view=detail&;id=2461&option=com_joomgallery&Itemid=178

http://www.zcentralstation.com/index.php?view=detail&;id=2458&option=com_joomgallery&Itemid=178

http://www.zcentralstation.com/index.php?view=detail&;id=2459&option=com_joomgallery&Itemid=178